Ski boot heel pads, 3D printed replacements

Why 3D print a replacement ski boot heel pad

A heel pad is a small part, but without it the boot is out of action.

Made to measure

Modelled from your own boot, for a precise fit.

Built to last

A technical filament chosen to take knocks, printed in the orientation that best handles the load on the heel.

Chosen for the cold

A material picked so that freezing temperatures don't make it brittle.

Binding fit

The original dimensions and tolerances are kept so the boot goes back into your bindings as before.

Heel pads for every ski boot brand

Salomon, Rossignol, Tecnica, Nordica, Head, Atomic, Lange, Dalbello and many others. Since each heel pad is modelled from your specific boot, the brand and model don't limit what we can do.

Rather than buying new boots that cost several hundred euros, have the broken part reproduced for a fraction of the price.

Replacing a ski boot heel pad: how it works

1. 1

   Send us your part

   Detailed photos of the broken heel pad through the contact form, or post us the part or the boot itself. We come back to you with a quote within 24 hours.

2. 2

   Made-to-measure 3D model

   We model the heel pad in 3D, keeping the original dimensions and the tolerances the bindings need.

3. 3

   Printing and delivery

   The part is printed in a cold-resistant technical material and sent ready to fit, or collected from our Toulouse workshop.

Once the new heel pad is on, have your bindings checked by a ski shop before you go back on the slopes, as you would after any repair to a ski boot.

Broken ski boot heel pad? A 3D printed replacement

A broken heel pad on a ski boot can make the whole boot unusable, even when the shell and liner are still in good shape. 3D printing lets us reproduce the broken heel pad to measure instead of sending you shopping for a new pair.

Each heel pad is modelled from your original part for a close fit, then printed in a technical material that withstands knocks and severe cold. Dimensions and tolerances follow the original so that it works with your ski bindings. On this page you can turn the 3D model of a heel pad we reproduced for a customer.

Send us photos of the broken part and you get a quote within 24 hours. Collect the heel pad in Toulouse, or we post it anywhere in France by Mondial Relay or Colissimo, and abroad on request. The service runs all year round, not only in winter. You can write to us in English: contact form with your photos attached, WhatsApp at +33 7 59 72 51 81 or contact@toulouse3dprint.fr.

Frequently asked questions

Is a 3D printed heel pad as strong as the original?

That is what we aim for. We use a technical filament chosen for its resistance to knocks and cold, and orient the print so the part is strongest where the heel takes the load.

Which ski boot brands can you make heel pads for?

All of them: Salomon, Rossignol, Tecnica, Nordica, Head, Atomic, Lange, Dalbello and others. Each heel pad is modelled for your specific boot.

How do I send you my broken part?

Send detailed photos through the contact form, or post the part to us. We come back to you with a quote within 24 hours.

Will the heel pad work with my ski bindings?

We keep the original dimensions and tolerances so the boot goes back into your bindings as before. As after any boot repair, have a ski shop check your bindings before skiing.

How much does it cost compared with new boots?

A fraction of the price of a new pair, which often costs several hundred euros. The quote is free.

Can I order outside the ski season?

Yes, the service runs all year round. Summer is a good time to get your boots ready for next winter.

How do I get the heel pad back?

Collect it from the workshop in Toulouse, or we post it anywhere in France by Mondial Relay or Colissimo. For another country, contact us: we ship by Mondial Relay or the carrier of your choice and give you the cost first.